First Period Of Use; Scheduled Maintenance Table - Viper AS6690T Kurzanleitung

QUICK START GUIDE
MACHINE STORAGE DURING LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Using the machine paragraph.
1.
Disconnect the battery connector (29, Figure 2).
2.

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for wear and
leakage.
MAINTENANCE
WARNING!
Maintenance procedures must be performed after the machine is turned off and the battery charger cable is dis-
connected. In addition, carefully read the safety chapters in the manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized Service Center. This
manual only describes the general and common maintenance procedures.
For other maintenance procedures that are not in below maintenance schedule table, please refer to the Service Manual that can be
consulted at any our company Service Center.

SCHEDULED MAINTENANCE TABLE

CAUTION!
The procedure marked with (1) must be performed when the machine is used after 8 hours for the first time. The
procedure marked with (2) must be done by Service Center that qualified by our company.
Procedure
Battery charging
Squeegee cleaning
Brush/Pad-holder cleaning
Tank cleaning
Tank sealing strip inspection
Float ball filter cleaning
Pad cleaning
Splash guard cleaning (only for disc machine)
Squeegee blade check and replacement
Cleaning water filter cleaning
Suction filter cleaning
WET battery fluid level check
Screw and nut tightness inspection
Lower Isolator (only for orbital machine)
Brush motor carbon brush check or replacement
Vacuum motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
Daily, after each Weekly
use
17
ENGLISH
semiannually Yearly
（1）
（2）
（2）
（2）
（2）