After Using The Machine; Using For The First Time; Maintenance And Care - Viper AS510C Betriebsanleitung

Alternatively, directly place draining hose to a low position or on the ground to make the water
outlet face downward (as show in B, Figure 8), and then twist open the water draining lid to drain
off the wastewater in the tank. After draining is completed, use pure water to cleanse the inside of
recovery tank.
CAUTION！
When draining the wastewater, the vacuum tube for waste must be folded or
lowered to a lower position (as shown in Figure 8 A or B), and then open the lid of
the vacuum tube for waste to drain the water. Do not make the outlet of the vacuum
tube for waste face upward to drain the water vertically. This is to avoid wastewater
spilling onto the operator.
Solution tank emptying
6. Complete Steps 1 to 4.
7. As shown in Figure 9, turn open the lid of Solution tank (A)
anticlockwise along direction C, and drain Solution tank
completely. Use pure water to cleanse the inside of Solution
tank. When work is completed, turn tight the lid of Solution tank
(A) clockwise in direction B.

AFTER USING THE MACHINE

When work is done and before leaving the machine, completes the
following steps:
1. Follow the procedure as described in aforementioned section
about installing and unloading the brush/pad-holder, and take off the brush/pad-holder.
2. Following the procedures described in related sections, drain the water completely in Solution
tank and recovery tank.
3. Complete the daily maintenance procedures (refer to the section on maintenance).
4. Store the machine, including the brush/pad-holder and squeegee, in a clean and dry place. The
squeegee should be lifted or taken off.

USING FOR THE FIRST TIME

After using for the first 9 hours, please check all parts to make sure nothing has become loose or
damaged during operation, and check if there are any visible damages or leakage.

MAINTENANCE AND CARE

The service life and the maximum operation safety of the machine are assured by proper and timely
maintenance and care.
The following table provides a general maintenance plan for the machine. The time intervals of
maintenance are determined to a large extent by the working conditions of the machine. These time
intervals should be formulated by the personnel responsible for the maintenance.
WARNING！
Only after the power of the machine is disconnected should these procedures be
performed. Before proceeding with any of the maintenance procedures, please
study carefully the related safety sections.
All maintenance in the plan or all additional maintenance must be done by qualified personnel or
authorised service centers.
This manual only relates the simplest and the most common maintenance procedures.
For any maintenance procedures other than those stated in this table of planned maintenance, please
refer to the maintenance manual of the service center.
USER MANUAL
VF90015-EU
ENGLISH
Figure 9
9