Regulating The Volume Of Water Flow; Machine Start And Stop - Viper AS510C Betriebsanleitung

2) If the two ends of the rear squeegee strip,
sections C and D, have a gap with the floor
or the downward pressure is relatively light,
adjust the handle in a clockwise direction
until the whole length of the rear squeegee
strip touches well with the floor. The front
squeegee strip should lightly touch the floor.
Solution tank filling
CAUTION！
Only low foam, nonflammable
detergents may be used. These
detergents must be suitable for the use
of scrubbers.
11. Open the water inlet cover (27) and add water to solution tank. Do not overfill the tank. Filling up
to near the edge of the filter holder of the water inlet will suffice. When preparing the cleaning
solutions, please follow the dilution rates supplied by the chemical manufacture and the water
temperature must not exceed 40

REGULATING THE VOLUME OF WATER FLOW

WARNING ！
Regulating the ball valve handle (A, Figure 5) must
be done under the condition when the power switch
(38) is in the "O" position.
12. The volume of the water flow may be adjusted through the ball
valve handle (A, Figure 5) according to the amount of water
practically required for scrubbing the floor.

MACHINE START AND STOP

Starting the machine
1. Complete the preparatory steps as related above.
2. Connect the power cable (9) to a corresponding voltage power supply, and press the power switch
(38) to the "I" position.
3. Use the squeegee handle (14) to lower the squeegee.
4. Press the Vacuum switch (39) to the "I" position.
5. Press the water flow volume control switch (40) to the "I" position. (Work simultaneously with the
safety switch (1) to control the work of solenoid valve.)
6. Hold the safety switch (1) and push to move the machine. The brush (29) starts to rotate, and the
machine starts its cleaning job.
CONSULTATION：The way to push the machine
One of the characteristics of the machine is the
Installation of two safety switches on both sides of
handlebar.
controlling independently the operation of the
brush. In use, it facilitates the control of the
operation of the machine.
By experience, the method to move the machine
shown on right Figure 6 is more suitable, the users
feel more comfortable on hands, it reduces work
fatigue. So the users are recommended to move
the machine in this way
0
C.
Each safety switch is capable of
.
USER MANUAL
Figure 4
VF90015-EU
ENGLISH
Figure 5
Figure 6
7