RS Pro FGA-1577A Bedienungsanleitung Seite 17

Drainage
When the unit is operating in Cooling or
Dehumidify ( DRY) mode, humidity extracted
from the air is collected in an internal tank.
If the tank reaches full, the compressor and
motor cut out automatically. At the same
time, the "Water Full" indicator comes on.
An alarm will also sound. When the tank is
full, carry out the following instructions:
Drain knob
Drain hole
Rubber plug
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (a water tray for example) underneath the drain hole.
3. Remove the drain knob & rubber plug from the drain hole and allow the water to drain out.
4. When the container is almost full, replace the rubber plug in the drain hole and empty the
water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the drain knob firmly.
7. Switch on the unit - the full water or compressor operating indicator should not be flashing.
rspro.com
17