Blackmagic Design URSA Mini series Installations- Und Bedienungsanleitung Seite 74

With 'off speed frame rate' enabled, tap the arrows on either side of the sensor
frame rate, move the slider or tap one of the presets to make adjustments
By default, your URSA Mini's project and sensor frame rates are matched for a natural playback
speed. However, by tapping the 'off speed frame rate' switch icon in the bottom right hand side
of your URSA Mini's 'FPS' menu, you can independently set your sensor frame rate.
To change your sensor frame rate, tap the arrows next to the sensor frame rate indicator in the
lower left of your touchscreen. You can also drag the slider left or right to increase or decrease
the frame rate. Once you release the slider, the sensor frame rate will be selected. Above the
slider, you can select a recommended off speed frame rate that is based on your current project
frame rate.
You can create dynamic and interesting speed effects in your clips by varying the sensor frame
rate. Setting the sensor frame rate higher than your project frame rate will create slow motion
during playback. Alternatively, the lower your sensor frame rate, the faster your clips will appear.
The principle is similar to overcranking and undercranking a film camera. Overcranking speeds
up the sensor frame rate so you can stretch out moments in time during playback to enhance
emotion. Undercranking slows down the sensor frame rate so you can increase the action in
fast moving scenes. The creative possibilities are endless and entirely up to you!
For information on the maximum frame rates available for each recording format and codec,
refer to the table in the 'recording' section of this manual.
NOTE When 'off speed frame rate' is selected your URSA Mini's audio and video are
no longer synced. This is true even if you set the same project and sensor frame rate.
For this reason, 'off speed frame rate' should never be selected if you want to
guarantee audio syncing.
Shutter
The 'Shutter' indicator displays your shutter angle or shutter speed. By tapping this indicator,
you can manually change your URSA Mini's shutter values or configure shutter priority auto
exposure modes. On URSA Mini 4.6K and URSA Mini Pro, the shutter measurement setting can
be used to select whether to display shutter information as 'shutter angle' or 'shutter speed'.
See the 'setup settings' section in this manual for more information.
Your URSA Mini's shutter indicator. Tap this to access shutter settings
Touchscreen Controls 74