Blackmagic Design URSA Mini series Installations- Und Bedienungsanleitung Seite 103

XLR Audio Settings 2
The second page of the 'XLR' audio tab contains the following settings.
Channel 1 and 2 gain
Move the slider left and right on the 'channel 1 gain' and 'channel 2 gain' settings to adjust the
audio levels for each channel.
Channel 1 and 2 Mic
The Mic option gives you added control of input gain levels on an external microphone by
setting the preamplification level to 'low' or 'high.' The 'low' setting can be useful when shooting
in a loud environment even after your input levels have already been turned down.
Channel 1 and 2 phantom power
Your URSA Mini's XLR inputs can provide 48V phantom power so you can use microphones that
aren't self powered. When your camera is set to 'XLR' audio input, simply tap the 'phantom
power' switch icon to enable phantom power.
NOTE It is standard practice to plug in your XLR cable before switching phantom
power on. It is also important to switch phantom power to 'off' when you no longer
have a phantom powered microphone connected. Connecting equipment that doesn't
require phantom power whilst still in phantom power mode can damage your
equipment, as the camera outputs a charge when in this mode. Phantom power can
also take quite a while to discharge after switching phantom power off on URSA Mini.
Please be aware that you should wait a few minutes when switching off phantom
power before plugging in any other microphones or XLR audio equipment.
Audio Settings – URSA Mini Pro
The audio settings for your URSA Mini Pro are spread over two pages and divided between
channels 1 and 2, while an upcoming software update will add two additional channels.
You can map each audio channel to a different source, as well as adjusting various settings
such as padding and low cut filters.
These settings work together with the switches on your URSA Mini Pro's internal control panel.
So after you've set your audio source for a particular channel, you can use the internal control
panel switches to set the signal type and whether phantom power is enabled for that channel.
Settings 103