Blackmagic Design URSA Mini series Installations- Und Bedienungsanleitung Seite 261

7
Loosely turn the five mounting screws until initial
contact is made with the shoulder of the lens
mount. To access all five screws, you will need
to rotate the PL locking ring, as some holes are
obscured when the ring is either open or closed.
Shimming URSA Mini Pro
Shimming URSA Mini Pro is almost the same as URSA Mini PL. The only difference is the shape
of the shims themselves. To shim your URSA Mini Pro, simply remove the attached lens mount,
and add or remove shims as you would for URSA Mini PL, then replace the mount.
See the 'Interchangeable lens mount' section for more information on attaching lens mounts to
URSA Mini Pro.
URSA Mini Pro's shims are C shaped to accommodate
the lens release mechanism in the EF mount. This
makes them easier to align as they can only fit one way.
Installation is otherwise identical to URSA Mini PL.
8
1
5
4
Using the torque wrench and 2.0mm Hex key,
apply one full turn of pressure to mounting screw
1, followed by one full turn to screw 2, repeat
for screws 3 and 4, then 5 and 6. Continue to
apply one full turn to each screw in the sequence
above until all screws have reached the
maximum torque of 0.45Nm.
Shimming Lens Mounts
3
6
2
261