Installation In Multiple Combinations - HomeMatic HMIP-WTH Montage- Und Bedienungsanleitung

• Now drill the bore holes.
• Use the supplied screws and plugs (R) to fasten
• Attach the clip-on frame (A) to the mounting
• Place the electronic unit (B) back into the frame
5.2.3
You can mount the wall thermostat with the attachment
frame (A) provided or use it with frames of other manu-
facturers as well as integrate the electronic unit (B) into
a multi-gang frame. You can flexibly fix the mounting
plate (F) to the wall using adhesive strips or screws. For
mounting with multiple combinations, make sure that the
Downloaded from www.Manualslib.com
The bore holes (Q) can be used for installation
with a flush-mounting box.
If you are working with a stone wall, drill the
marked 5 mm holes and insert the plugs supplied.
If you are working with a wooden wall, you can
pre-drill 1.5 mm holes to make screws easier to
insert.
the mounting plate to the wall (see figure 5).
plate.
(see figure 1). Make sure that "TOP" and the ar-
rows on the back side point upwards and that the
clips on the mounting plate latch into the open-
ings on the electronic unit.

Installation in multiple combinations

manuals search engine
Start-up
33