Analog Start Position / Analog End Position - TR-Electronic 582 Serie Benutzerhandbuch

Parameterization via TRWinProg

4.4.4 Analog start position / Analog end position

The active analog measuring range can be defined within the maximum values using
the two parameters Analog start position and Analog end position.
Depending on the set "Data type" (chapter: 4.4.2), the entry is made in steps or in
the unit defined under "Speed unit" (chapter: 4.1.3). The start position analog must
be defined smaller than the end position analog and the end position analog smaller
than the maximum measuring length or the maximum permissible speed.
Figure 11: Active measuring range, rotation = CW; counting direction = increasing
Legend
A
O
A
U/I max
A
I min
A
U min
ML
Pos
Start-Pos = programmed Analog start position (steps / speed*)
End-Pos
* signed
 TR-Electronic GmbH 2020, All Rights Reserved
Page 64 of 72
= actual measured Analog output quantity (voltage* / current)
= positive maximum value of the analog output quantity (voltage* / current)
= negative maximum value of the analog output quantity (current)
= negative maximum value of the analog output quantity (voltage*)
= maximum value (steps / speed*)
= actual Position or Speed* of the measuring system
= programmed Analog end position (steps / speed*)
TR - ECE - BA - DGB - 0162 - 00
Printed in the Federal Republic of Germany
07/31/2020