Dell PowerVault NX1950 Installationsanleitung Seite 13

Using the Special Administration Console
Figure 1-3. Use the Console Cable to Connect to the SAC Prompt
In an environment that does not support DHCP , you can use CLI support
in SAC to connect through a serial port to a system running Windows
Unified Data Storage Server 2003 and configure network settings. After
you configure the network using SAC, you can remotely access the
graphical user interface (GUI) to configure and manage Windows Unified
Data Storage Server using the IP address. To do this, you need to:
Downloaded from www.Manualslib.com
NOTE:
To use SAC, you require a female-to-female serial console cable to
connect directly from a client system to the PowerVault NX1950 storage system
as shown in Figure 1-3.
PowerVault NX1950
storage system
NOTE:
Ensure that the hyper-terminal settings are set to—115200 baud, 8 data
bits, No parity, 1 stop bit.
• Access the SAC command prompt
• Configure IP addresses and Domain Name System (DNS)
manuals search engine
female-to-female serial
console cable
client system
Installation Guide 11