Safety Instructions; Operation - Schwamborn DSM 250 Originalbetriebsanleitung

EN Floor grinding machine DSM 250
2 Safety
The manufacturer and owner of the machine must
observe the contents and provisions of the EC direc­
tives. The effectiveness of any measure ultimately
depends on how well all parties, i.e. the manufac­
turer, the owner and the machine operators, work
together to uphold safety standards.
All laws and regulations (e.g. the valid regulations on
waste disposal), accident prevention guidelines and
generally recognised safety rules must be complied
with when working on and with the machine!

2.2 Safety instructions

This machine incorporates state of the art technology
and has been built in accordance with recognised
safety regulations. This ensures that the highest pos­
sible standards of occupational safety are main­
tained. However, incorrect use of the machine could
endanger the health and lives of the personnel or
cause material damage.
The machine may only be operated by people
who have been assigned to do so and who have
the appropriate training and skills!
If any defects are found in the machine that
could endanger people or damage property,
stop the machine immediately and ensure that it
cannot be used again until all repairs have been
completed!
The operating and maintenance personnel re­
sponsible for the machine must ensure that no
one can enter the machine's danger zone during
operation or maintenance work!
Risk of injury if safety equipment has been re­
moved or is non-functional!
The safety equipment must be checked for com­
pleteness and function before start-up!
The safety equipment must be in place during

operation!

The surfaces to be ground by the machine must
be free of obstacles.
When working on the machine (setup, mainte­
nance, service, repair, cleaning, etc.), the power
supply of the machine has to be disconnected
from the mains (pull plug).
Risk of injury from rotating machine parts!
Limbs and clothing can be drawn in!
Proceed with the greatest care and caution!
High-voltage electrical current can be fatal!
Only connect the machine to power supplies
equipped with a ground fault circuit interrupter!.
Connections with mains cables must be pro­
tected from splash water!
Only suitably knowledgeable, qualified profes­
sional electricians may perform work on any
electrical parts of the system!
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking and smoking at the workplace is
not permitted. Always eat in break rooms or
canteen areas!
After completing the work, thoroughly clean
yourself!
A general inspection of the machine must be
conducted before starting up the machine! Par­
ticular attention should be paid to damaged or
loose components, and wear!
The machine may only be put into operation if it
is in perfect technical condition!
Adding to or modifying the machine in any way
that could compromise operating safety is pro­
hibited!
Cleaning and maintenance may be done only by
trained personnel!
Maintenance must be conducted as described in
the operating instructions!
Do not use high pressure cleaners to clean the
machine!
Do not operate the machine in areas where
there is risk of explosion or where flammable
materials are present.
Risk of damage due to excessive extraction ca­
pacity!
The manufacturer strongly recommends to use
extraction devices of the
Schwamborn brand only.
15