Operation - Parkside HG04678 Bedienungs- Und Sicherheitshinweise

ATTENTION! The irrigation
controller may only be connec-
ted to a drinking water abs-
traction point with a safety
device which corresponds to
TYPE HD at the very least ac-
cording to EN 1717 (back-
flow preventer with tube
ventilation).
Note: Such mains adapters
are available from speciality
retailers.
Check the water connection
type available. The product is
fitted with a union nut
a tap with a 33.3 mm thread
(G 1"). For a tap with a
26.5 mm thread (G ¾") use
the adapter supplied
Insert the filter
union nut
Figure A.
For a 26.5 mm thread (G ¾"):
Screw the adapter
the tap. Do not use any tools
for this purpose.
Screw the union nut
the thread of the tap or the
40 GB/IE
for
1
.
10
into the
9
as depicted in
1
onto
10
onto
1
adapter. Do not use any tools
for this purpose.
Screw the connector
the hose connection. You can
then connect a hose to the
connector
11
Open the tap.
ATTENTION! If defects /
leaks arise when using the
adapter
10
the tap must be wrapped
using sealing tape.
Programme irrigation as
described in the chapter

„Operation".

Operation
Irrigation can be fully automated
at any time of the day using the ir-
rigation controller. A sprinkler,
sprinkler system or drip irrigation
system may be connected.
The irrigation controller automati-
cally carries out irrigation at the
respective programmed start time
and for the programmed dura-
tion. Take the season and time of
the day into consideration when
onto
11
.
, the thread of