Operation; Before Getting Started; Switching The Appliance On And Off; Setting The Temperature - hanseatic SC-130 Gebrauchsanleitung

Page EN-10

Operation

Operation

Before getting started

– Read the „Safety" chapter from page EN-5.
– Set up and connect the appliance as
described in chapter „Start-up" from
page EN-16.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may get into the cool-
ing circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting.
(6)
Switching on
1. Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
2. Turn the temperature controller (6) to a
value higher than '0'.
The appliance is then switched on. The
compressor starts to work, the refrigerant
flows through the pipes and a quiet hum-
ming sound can be heard.
Switching off
1. Turn the temperature controller (6) to '0'.
The compressor is switched off. The appli-
ance will no longer be cooling, but will still
have electricity.
2. Pull the mains plug out of the socket.
The compressor is switched off. The appli-
ance no longer refrigerates.
3. Empty the appliance and clean it (see
'Care and maintenance' on page EN-14).
4. Leave the glass door slightly ajar to pre-
vent mould from forming.
After switching off , wait for approx. 5
minutes before switching the appli-
ance back on. The compressor requires this
amount of time to re-start.

Setting the temperature

WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always adhere to the prescribed am-
■
bient temperature (see correspond-
ing product data sheet at the end of
this user manual).
The Temperature controller (6) is located in-
side the appliance.
The appliance's interior temperature can be
adjusted in increments of '1' to '7':
– Set the temperature to '7' for the maximum
chilling capacity and therefore the lowest
temperature possible.
– Set the temperature to '1' for the minimum
chilling capacity.
– '0' is used to switch off the cooling.