Technical Data; Safety Adjustments - MTR+ MyoBravo Bedienungsanleitung

Channels:
Waveform:
Intensity:
Frequency:
Width of impulse:
Ramp up/down time:
Time setting:
Electrical supply:
Resistor:
U max:
Environmental conditions for storage, transportation & use: -10 to +50 degree
centigrade, 0-90 % atmospheric humidity, air pressure of 700-1060 hPa
Explanation of Symbols
Operators Manual
This device is quality controlled and fulfils the rules and regulations set by the
German law for medical products (MPG) as well as the guidelines of the Euro-
pean Community 93/42/EWG for medical products. Therefore this device car-
ries the CE-sign „CE 0123".
You can find the serial number of this device in the battery compartment.
Manufacturer: MTR+ Vertriebs GmbH, Kamenzer Damm 78, 12249 Berlin
1. The +buttons get inactive after one minute running time of a program to
avoid an unintentional increase of intensity . This lock is switched off again,
only by pressing the +button three-times repeatedly. Now an increasing of
intensity is possible again for another minute.
2. If the electrical circuit should be interrupted for example by losing an
electrode or by a broken lead wire, the device switches off immediately, if it has
been above an intensity of 6 mA.
3. If any phase comes to its end the intensity falls down to 8 mA automatically
and must be regulated by the user on a pleasant measure again.
Downloaded from www.Manualslib.com
Attention!
Please consider

Safety Adjustments

manuals search engine
MyoBravo Bedienungsanleitung / Operators Manual

Technical Data

Two isolated independent channels
Symmetrical, rectangular, bi-phasic with zero
DC current
0 - 90 mA
2 - 200 Hz
50µs - 300µs
0,1 seconds - 9,9 seconds
variable: 1 minute - 9 hours + 59 minutes
9 volt block battery
500 Ohm 1000 Ohm
24 V 47 V
0123
CE-Sign
49
3000 Ohm
130 V
Grade of protection BF