Troubleshooting - eta FALCO SMART Bedienungsanleitung

EN
Use dry cloth to clean both charging pin on the bottom of robot and on the charging
base.
* Please take out the batteries if stop using for a long time.
5.5. Replace / remove the battery
To replace or remove the battery, unscrew the 4 screws of battery lid A6. Disconnect the
connector and remove or change the battery. Place the battery lid and screw all screws
back into place.

7. TROUBLESHOOTING

When the robot has problems, the display panel will show different error code and
send beep sound of varying lengths. Please refer to the following table for problems
and reasons.
Reason
01 Left wheel
abnormal
02 Right wheel
abnormal
03 Left brush
abnormal
04 Right brush
abnormal
05 Main brush
abnormal
06 The robot is not
on the floor
Display Prompt
Panel Tone
1
E11
1
E12
1
E13
1
E14
1
E15
2
E21
EN - 76
Solutions
Check left wheel
Check right wheel
Check left brush
Check right brush
Check main brush
Move robot to open place,
and restart it.