Stahl SolConeX 8570/11-Serie Betriebsanleitung Seite 33

Mounting and installation
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Installation of auxiliary contacts
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
14
Downloaded from www.Manualslib.com
SolConeX Wall-Mounted Socket, 16 A
Series 8570/11
manuals search engine
• Open the enclosure. Guide the
cables through the cable entry into
the connection chamber. Strip the
cables. Insert the conductors into
the corresponding terminals and
clamp them (for tightening torque,
see chapter "Technical data"). Insert
the stripped cable ends completely
11201E00
under the clamping plate. Check if
the conductors have been clamped
properly. Align the conductors.
Make sure that the clamping points
are not under tension. Tighten the
cable entry/entries. Close the
enclosure (for the tightening torque,
see chapter "Technical data").
• Open the enclosure.
• Lead the cable through the cable
gland into the connection chamber.
• Unlock the screwless type terminals
by means of a screwdriver (2)
(cutting edge 06 x 3.5 form A
according to DIN 5264 or
16027E00
ISO 2380-1).
• Insert the conductors in the
corresponding screwless type
terminals and clamp them (3).
The stripped conductor ends must
be fully inside the terminal.
• Align the conductors (the clamping
units must not be under tension).
11202E00
• Tighten the cable gland(s).
• Close the enclosure (for the
tightening torque, see chapter
"Technical data").
150646 / 8570601300
2017-07-19·BA00·III·en·07