Specifications; Important Safety Instructions - Makita BML360 Betriebsanleitung

ENGLISH
1. Battery cartridge
2. Button
3. Red part
4. Switch

SPECIFICATIONS

Power source
Fluorescent tube
Dimensions
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
IMPORTANT SAFETY
INSTRUCTIONS
WARNING:
When using electric tools, basic safety precautions should
always be followed to reduce the risk of fire, electric
shock, and personal injury, including the following:
READ ALL INSTRUCTIONS.
1. Read this instruction manual, battery instruction
manual and the charger instruction manual carefully
before use.
2. This Fluorescent light and battery cartridge are not
waterproof. Do not use it in damp or wet locations. Do
not expose it to rain or snow. Do not wash it in water.
3. A short-circuit can cause a large current flow,
overheating, possible burns and even a breakdown.
(1) Do not touch the inside of the Fluorescent light
with tweezers, metal tools, etc.
(2) Do not touch the battery terminals with any
conductive material.
(3) Avoid storing the battery cartridge in a container
with any metal objects such as nails, coins, etc.
4. Never expose the battery cartridge to flames, fire or
great heat. Breakage may cause release of injurious
material.
5. If electrolyte gets into your eyes, rinse them out with
clear water and seek medical attention right away. It
may result in loss of your eyesight.
6. If operating time has become excessively shorter, stop
operating immediately. It may result in a risk of
overheating, possible burns and even an explosion.
7. Be careful not to drop, shake or strike battery.
Do not use dropped or struck battery.
8. When the tool is not in use, always switch off and
remove the battery cartridge from the tool.
9. Do not store the tool and battery cartridge in locations
where the temperature may reach or exceed 50°C
(122°F).
4
Explanation of general view
5. Screw A
6. Bumper
7. Screw B
8. Light cover
Model
When light is upright
Net weight
L
W
H
10. Do not give the tool a shock by dropping, striking, etc.
11. Do not expose the light to eyes continuously. It may
hurt them.
12. Do not cover or clog the lit tool with cloth or carton,
etc. It may create a risk of fire.
13. Switch off the light immediately when the lamp gets
dark in use. If you leave the lamp switched on, the
battery cartridge capacity may decrease.
14. Do not disassemble the charger or battery cartridge;
take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk
of electric shock or fire.
15. If any problem develops, consult your nearest Makita
Service Center or dealer. To maintain product safety
and reliability, repairs, maintenance or adjustment
should be carried out by Makita Authorized Service
Center.
16. If you notice that the tool is hot or in abnormal
condition, consult your nearest Makita Service Center
or dealer. When the switch is turned "ON", the handle
of the tool may become slightly hot, even if the
fluorescent tube is not installed or is not lighted. This
is a normal condition and does not indicate problem.
Battery tool use and care
17. Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
18. Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
19. When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fire.
20. Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
9. Fluorescent tube
10. Socket
11. Cushion
12. Shoulder strap (Accessory)
BML360
D.C. 36V
FML27EX-N
283 mm
128 mm
203 mm
2.3 kg