Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dichtung montieren
Couple the Liquid End
a. Reassemble the Liquid End, mount the lower part of the ejector unit, and check for leak-tightness.
b. After checking the Liquid End, couple it onto the motor control unit again.
For the check, we recommend the BRAND PLT leak testing unit. If the Liquid End is not leak-tight, please
contact the Support department of the manufacturer.
Liquid Handling Station 9974 96
a. If necessary, reoil the piston slightly with the supplied sili-
cone oil. Only use the recommended silicone oil.
b. Slide the seal onto the piston with the flat side upwards.
c. Tighten the cleaned or new shaft using the supplied
mounting tool.
NOTICE
Maintenance/Cleaning
Operating manual English
81
Werbung
Kapitel
Inhaltsverzeichnis
