Legal Information - Ottobock 28F10 Gebrauchsanweisung

CAUTION
Incorrect or excessively tight application
Risk of local pressure and constriction of blood vessels and nerves due to improper or excess­
ively tight application
Ensure that the product is applied properly and fits correctly.
►
NOTICE
Use of a worn or damaged product
Limited effectiveness
Before each use, check the product for functional reliability and for possible wear or dam­
►
age.
Do not continue using a product that is no longer functional, or that is worn or damaged.
►
1) Open the hook-and-loop closures and the zip fastener.
2) Place the foot in the orthosis (see fig. 21). The toes should be placed in the orthosis first.
3) Close the hook-and-loop closures on the instep and lower leg, ensuring they exert even pres­
sure (see fig. 22).
4) Close the zip fastener (see fig. 23).
6 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
Only clean the product with the approved cleaning agents.
►
> Allowable cleaning agent: pH neutral soap (e.g. 453H10 Derma Clean)
Orthosis frame
1) Wipe with a damp cloth as needed.
2) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
Straps and pads
1) Remove the straps and pads from the orthosis.
2) Close all hook-and-loop closures.
3) Hand-wash the straps and pads in warm water at 30 °C (86 °F) using neutral detergent.
Rinse thoroughly.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
7 Disposal
Dispose of the product in accordance with national regulations.

8 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
8.1 Local Legal Information
Legal information that applies exclusively to specific countries is written in the official language
of the respective country of use after this chapter.
8.2 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
17