Unit Description; Initial Use; Operation - Sanitas SIL 29 Gebrauchsanweisung

Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

1
3
4

5. Initial use

Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.

6. Operation

1 Switching on the lamp
 To connect to the mains, fully insert the plug into the socket. Once inserted, the LED will flash. This is
the readiness indicator (standby). Press the On/Off button (4) once to switch on the lamp.
2 Enjoying the light
The recommended duration of treatment is maximum 15 minutes and should be limited to a maximum of
two treatments a day. We recommend selecting a shorter radiation period to start with. However, the skin
of some people may show an over-sensitive (e.g. with extreme redness, blistering, itching, heavy swea-
ting) or allergic reaction to heat radiation, even when the lamp is used correctly.
3 Timer/Standby
Press the on/off button (4) to start the timer.
The lamp switches off automatically once 15 minutes have elapsed.
Press the on/off button (4) to manually switch off the infrared lamp early.
1. Light source
2
2. Lamp shade
3. Base
4. On/Off button
5. LED readiness indicator/standby
5
9