Changing The Infrared Lamp; Cleaning And Care Of The Unit; Disposal; Technical Specifications - Sanitas SIL 29 Gebrauchsanweisung

4 Important instructions
The distance between the infrared lamp and the radiated part of the body should not be less than the
following: at least 32 in (80 cm)
Protective eyewear which corresponds to the requirements of DIN EN 171 2002 must be worn for treat-
ment distances under 80 cm.
For treatment distances above 80 cm, closing your eyes is sufficient.
CAUTION: Never look directly into the infrared light without protective eyewear.
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of an
over-sensitive or allergic reaction appear and consult a physician.
5 Switching off the lamp
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it away and/or pack it up!
Please note that the mains cable must not be wound round the infrared lamp either for storage or when in use.
Disconnect the mains plug from the socket to fully switch off the device.

7. Changing the infrared lamp

The device must be switched off and allowed to cool and the mains plug pulled out before cleaning and changing
the infrared heat lamp.
Please note that only infrared lamps of the original type may be used as replacements.
Replacement infrared lamp (type)
Infrared PAR 38 (150 W)
Warning
• Do not touch the infrared lamp or unscrew it when it is connected to the mains.
• Unplug the device, to avoid the risk of electrocution.
• In the interest of environmental protection, do not dispose of the device in household waste.

8. Cleaning and care of the unit

The unit should be cleaned occasionally.
Important
To avoid odours caused by fluff and dust, we recommend regularly cleaning the device as follows:
• The device must be switched off and allowed to cool and the mains plug pulled out before cleaning and
changing the infrared heat lamp.
• Ensure that no water penetrates inside the unit!
• Do not wash the unit in a washing machine!
Clean using a damp cloth, to which you can apply a little detergent if necessary.
• Do not use abrasive detergents and never immerse the unit in water. Do not touch the unit with wet hands
while it is plugged in; do not allow any water to be sprayed onto the unit.
• The unit must be operated only when it is completely dry.

9. Disposal

In the interest of protecting the environment, the unit must not be thrown out with the household waste at the
end of its service life. Dispose of the unit at a suitable local collection or recycling point.
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment).
If you have any queries, please contact the appropriate local authorities.

10. Technical specifications

Mains connection
Power consumption
Dimensions (W x H x D)
Max. Radiation intensity
Specifications
: :
230V ~ 50 Hz
220-230 V~ / 50-60 Hz
150 W
145 x 220 x 175 mm
550 W/m at 80 cm
2
10
Item number:
616.51