Maintenance And Environmental Protection - MEISTER CRAFT MMS 710 E Betriebsanleitung

5454150-Multi-Elek-man 14.03.14 14:22 Seite 42
turn the device off immediately. Use a
suitable tool to open up the cut a little
and remove the device. When you have
finished working, switch off the machine
and only put it down when it has come
to a complete standstill.
CAUTION! After working with
a low stroke rate for a long
period of time, operate at maximum
revolutions in idle mode for about
three minutes to allow the machine
to cool down.
CAUTION! When sawing metal,
and steel in particular, regularly
cooling breaks should be taken in order
to allow the saw blade to cool, or brush
the blade with a cutting oil! This will
considerably increase the durability and
edge retention of the blade.
Sawing without pilot hole (Figure 7)
With the saw blade in a tipped machine
position and the machine running,
careful guide it across the work piece (a).
As soon as the work piece has been
sawn through, continue working with the
machine in the normal position (b).
CAUTION! Such usage is only
possible with short blades and
soft materials, such as soft wood or
insulation materials.
Sawing flush (Figure 8)
When used in conjunction with elastic bi-
metal blades (not included) you can, for
example, cut projecting elements (water
pipes etc.) directly flush with the wall.
Place the saw blade up directly against
the wall and use lateral pressure on the
machine to bend it until the saw shoe (2)
lies against the wall. Switch the machine
on and apply constant, lateral pressure
42
while sawing off the work piece.
Application examples
Figure 9: Sawing plastic/metal
Figure 10: Aerated concrete
Figure 11: Cutting wood
10 – Maintenance and
environmental
protection
CAUTION! Unplug from the
power source!
Never submerge electrical machinery in
water. Additional notes can be found in
the operating instructions.
Wipe the housing with a damp cloth
and dry well. Do not use any cleaning
products. Remove the dust from the
ventilation slots and the blade holder,
and if necessary use a vacuum
cleaner.
CAUTION! Electrical and battery
operated units that no longer
work should not be disposed of in the
household waste! They are to be
collected separately, in
accordance with the
2012/19 EU directive for
the disposal of electrical
and electronic waste, and
sent for proper and
environ mentally-friendly
recycling.
Please discard power tools no longer
usable at a local collection point.
Collection and disposal of packaging
materials separately by types
complying with local rules and
regulations. For details, please
contact your municipal authority
concerned.