Herunterladen Inhalt Inhalt Diese Seite drucken

GLOBBER ONE K E-MOTION 15 Benutzerhandbuch Seite 5

Vorschau ausblenden Andere Handbücher für ONE K E-MOTION 15:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING! RISK OF INJURY BY PINCHING!
DO NOT INSERT YOUR FINGERS INTO THE
SHADED AREA INDICATED.
For first time users, please install the handlebar by
placing it in the housing at the top of the steering
column and secure the clamp with the 4 bolts.
SELF-STANDING MODE
This scooter can be put in self-standing mode by
simply moving the T-bar towards you, after you
have stepped on the Folding Lever. The wheel will
be slightly raised from the ground, for the scooter to
freely balance.
FOLD THE SCOOTER
1. Move the Folding Lever from a vertical to horizontal position. You can do this with
your foot or hand.
2. Step on the Folding Lever with strength until the folding mechanism is
disengaged.
3. Lower down the t-bar until the folding mechanism clicks into place.
(a "click" sound will be heard)
FOLDING MECHANISM MAINTENANCE:
The folding mechanism might become loose after excessive use.
If such a case arises, please use the provided hex wrench to
slightly tighten the two bolts (Only slightly tighten the bolts to avoid
negatively impacting the folding mechanism).
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- This scooter has a Kick Start function.
- To start, push your scooter forward, the motor engages when speed reaches
5km/h. The battery lights signal on the deck will turn on; you are now in the "ON"
mode.
- Your E15 will turn off automatically after 1 minute of inactivity; the battery lights
signal will also go off.
START-UP
- Place a foot on the round acceleration sensor located at the top of the deck.
- You are in a position to start: push the scooter with your foot with more than 5
km/h to engage the electric motor. Be aware that once the motor is turned ON,
reducing your speed below 5km/h does not automatically cut the motor, read the
paragraph STOP for instructions on how to switch off the motor.
CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake
located at the rear of the scooter (mudguard) or/and use the acceleration sensor
located on the top of the deck.
(Press with your foot to accelerate, remove your foot to slowdown)
- Once the electric motor is engaged, it will accelerate until reaching the cruising
speed of 18 km/h.
- The rear brake generates both mechanical and electrical braking that reduce the
braking distance.
- WARNING! Engaging the brake (mudguard) automatically interrupts the motor
when the brake is pressed for less than 3 seconds. If you release the brake, the
motor automatically engages again.
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

653-100

Inhaltsverzeichnis