Technical Description; Construction; Dimensions; Functional Description - oventrop Unibox T RTL vario Betriebsanleitung

Technical description

3. Technical description

3.1 Construction

1 2 3
Illustr. 2: Construction of "Unibox T RTL
vario"
(1) Fixing bracket
(2)
Wall box unit
(3) Thermostatic valve connection for
remote control (control piston)
(4) Venting and flushing valve
(5) Valve with presettable insert and inte-
grated return temperature limiter
(6) Valve connection G ¾ male thread
(cone "Euro" according to DIN EN
16313)
30
4
5
6

3.2 Dimensions

135

Illustr. 3: Dimensions in mm

3.3 Functional description

The "Unibox T RTL vario" is intended for indi-
vidual room temperature control and for limiting
the return temperature in a surface temperature
balance.
The integrated thermostatic valve is equipped
with a presettable valve insert and thus enables
the flow rate to be accurately adapted to the
required heat demand (see chart in the appen-
dix) and hydraulic balancing to be carried out.
The installation position of the "Unibox T RTL
vario" should be chosen so that fluid flows first
through the heating circuit and then through
the "Unibox T RTL vario" valve. The heating
fluid cools down between the entry point of the
heating surface and the "Unibox T RTL vario".
The flow rate is controlled by the sensor ele-
ment located in the volume flow. The self-act-
ing thermostat controls the desired room
temperature. The temperature of the surface
temperature balance can be corrected by turn-
ing the handwheel of the return temperature
limiter (see 3.4.1 on page 30). The desired
room temperature can be set by turning the
handwheel of the self-acting thermostat.

3.4 Operating elements

3.4.1 Return temperature limiter

You can set the desired fluid temperature for
the surface temperature balance with the hand-
wheel. The return temperature limiter integrated
in the valve detects the fluid temperature flow-
Unibox T RTL vario
57
190
102273480-V01.07.2019