Safety Device - Gaspardo F Plus Gebrauch Und Wartung

Safety and maintenance
During work and maintenance operations, use suitable perso-
nal protection gear:
Overalls Gloves
50) Never carry out maintenance or cleaning work unless the pto
has been disengaged, the engine switched off, the hand
brake engaged and the tractor locked in position by a block
or stone under the wheels.
51) Periodically check that the bolts and nuts are tight, and if
necessary tighten them again. For this it would be advisable
to use a torque wrench, respecting the values of 53 Nm for
M10 bolts, resistance class 8.8, and 150 Nm for M14 bolts
resistance class 8.8 (Table 1).
52) As a precaution, always set adeguate supports under the
implement during assembly, servicing, cleaning or assembly
work with the mowing bar raised.
53) Before approaching the mowing bar, disengage the pto,
switch off the tractor, engage the parking brake and check
that the cutters are at a acomplete standstill.
54) The spare parts must correspond to the requirements
established by the manufacturer. Only use genuine spare
parts.
55) Do not climb onto the machine while it is running, even if it is
stationary.

2.1 SAFETY DEVICE

Cutting bar guard
For the purposes of transportation and parking, the mowing bar
is equipped with protective metal plating running its entire length
(A, Fig. 8). This guard is also equipped with 2 statutory reflectors
(B, Fig. 8).
Automatic frame release
The mower is equipped with a safety device to protect against
obstacles. When, due to a blow, it becomes unhooked, stop
without lifting the bar. Ensure that the universal shaft is not
damaged and reverse until the safety device re-engages itself. If
it tends to detach itself too easily, adjust the spring (C) using the
nut (D) tightening it by 180° at a time. (Fig. 9).
cod. G19503211
USE AND MAINTENANCE
Shoes Goggles Ear defenders
g
A
B
C
ENGLISH
Table 1
B
Fig. 8
D
15 mm
(standard)
Fig. 9
33