Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
1.3 DESCRIPTION OF THE MOWER
This agricultural implement can only operate by means of a cardan
shaft applied to the pto of an agricultural tractor equipped with lift
and universal three-point hitch front or small reversible tractors.
Model «F» is particularly suitable for mowing on sloping, hilly
grounds, this mower works on the same operating principle used
for FBR models, of which it has the features and advantages.
Since it is movable, the mowing machina can be easily mounted
on tractors with different gauges or on tracked vehicles.
The two-motion tooth-blade system used in mowing machines,
makes possible a scissors cut which leads to a higt speed
operation on a any crop. The original tooth-blade motion
guarantees a sharp and clean cut on any type of grass, be it
damp or flattened.
It is thanks to the total absence of soil which this mowing system
does not raise, sharp because the stems are not frayed.
It uses a blade 1,75 - 2,05 - 2,35 meter long
ADVANTAGES
- Direct visual surveillance of mowing;
- Excellent stability on sloping grounds;
- Possibility of using the rear drive take-off of the tractor for other
tasks (eg. loading grass, hay, etc.).
ATTENTION
The mower is suitable only for the uses indicated. Any other
use different from that described in these instructions could
cause damage to the machine and represent a serious hazard
for the user.
It is therefore advisable to strictly comply with the following
instructions in order to prevent faults which could jeopardize the
correct and long-lasting operation of theimplement. Compliance
with the instructions in this handbook is also important since the
Manufacturer declines all and every responsibility for damage
to persons or property caused by negligence and failure to
comply with these instructions. The Manufacturer shall, however,
remain at the customers' disposal for immediate and thorough
assistance together with anything else that may be required in
order to ensure the correct operation and maximum efficiency of
the implement.
1.4 TECHNICAL DATA
Cutting arm lenght
Weight
Power take-off revs
Schinitt (max)
Power required
No-load noise detection (*)
(*)
L
= Acoustic power level uttered by machine (Weighed A);
WA
L
= Continuous equivalent acoustic radiation pressure level (Weighed A) in the "worker's position".
pA
The technical data and the models provided must be considered as non binding. We reserve the right to change them without
notice.
28
USE AND MAINTENANCE
U.M.
[m]
1,75
[kg]
245
[r.p.m.]
[Km/h]
[HP - (kw)]
25 - (19)
[dB]
g
F Plus
2,05
2,35
265
285
540 - 1000
10÷12
35 - (26)
60 - (45)
(L
= 110,7) - (L
= 91,7)
WA
pA
cod. G19503211
2,80
395
70 - (52)
Werbung
Inhaltsverzeichnis
