Christie LWU720i Bedienungsanleitung Seite 37

Arrangement (continued)
WARNING ►Install the projector where you can access the power outlet
easily.
►Install the projector in a stable horizontal position.
• Do not use any mounting accessories except the accessories specified by the
manufacturer. Read and keep the manuals of the accessories used.
• For special installation such as ceiling mounting, be sure to consult your
dealer beforehand. Specific mounting accessories and services may be
required.
• Do not put the projector on its side, front or rear position.
• Do not attach nor place anything on the projector unless otherwise specified
in the manual.
►Do not install the projector near thermally conductive or flammable things.
►Do not place the projector where any oils, such as cooking or machine oil,
are used. Oil may harm the product, resulting in malfunction, or falling from the
mounted position. Do not use adhesive such as threadlocker, lubricant and so on.
►Do not place the projector in a place where it may get wet.
►Do not block the intake vents and exhaust vents of the projector. If the intake
vents and exhaust vents of the projector are blocked, the accumulated inside
heat may cause fire.
CAUTION ►Place the projector in a cool place with sufficient ventilation.
• Do not stop up, block nor cover the projector's vent holes.
• Do not place the projector at places that are exposed to magnetic fields, doing
so can cause the cooling fans inside the projector to malfunction.
►Avoid placing the projector in smoky, humid or dusty place.
• Do not place the projector near humidifiers.
NOTICE ►Position the projector to prevent light from directly hitting the
projector's remote sensor.
►Positional deviation or distortion of a projected image, or shift of the focus
may occur due to ambient conditions, and so on. They tend to occur until the
operation becomes stable, especially within about 30 minutes after the lamp is
turned on. Check and readjust them as necessary.
►Do not place the projector in a place where radio interference may be caused.
►Set the ALTITUDE of the SERVICE item in the OPTION menu correctly. It is
recommended to leave it at AUTO usually. If the projector is used with a wrong
setting, it may cause damage to the projector itself or the parts inside. For details,
see User's Manual - Operating Guide.
NOTE
• When the temperature inside the projector rises high, it may cause the
high rotation of the fan for cooling temporarily.
LWU720i/LHD720i/LWU620i
Setup Guide
8
020-001337-01 Rev. 1 (10-2017)