Corghi EYELIGHT Plus DiagnosticLine Betriebsanleitung Seite 54

Note: a different type of weight can also be se-
lected at the end of the dimension measurement
and unbalance calculation cycle.
Note: the Static programme, that uses only one
weight, is activated by selecting the icon for the
desired weight on the touchscreen and disabling
the icon that is not required.
POSITION INDICATORS
AND ALARM INDICATOR
LIGHTS
The wheel balancer has two round indicators for
the positioning of unbalances.
Each indicator has a button for changing the unbal-
ance unit of measurement from grams to ounces
and vice versa.
By selecting the central part of the indicator, an
automatic centred position search starts if the
unbalance is higher than zero.
At the end of the dimension and unbalance meas-
urement cycle, warning indicators may come on if
the set acceptable tolerances are exceeded (see the
"Wheel balancer parameter configuration" section):
1. WARNING OPT
This recommends performing the unbalance
optimisation procedure. Select the icon to start
the unbalance optimisation procedure (see the
"Unbalance Optimisation programme" section).
2. WARNING ROD
ROD program disabled, NOT activated
54
3. WARNING TYRE
The working environment has different spin types
that the operator can select based on his requi-
rements, i.e.:
•
•
EYELIGHT Plus DiagnosticLine - Operator's manual
ROD program is activated, it does
NOT recommend running the RUNOUT analysis
procedure as all detected parameters are within
the set threshold.
ROD program is activated and recom-
mends running the RUNOUT analysis procedure.
If you select the icon, the measured value of
the radial eccentricity of the wheel assembly
is displayed
ROD program activated and recom-
mends running the geometric wheel MATCHING
procedure. If you select the icon you can make
the wheel geometry MATCHING..
the ROD program is activated and
does NOT recommend displaying tire parameter
values as all parameters detected are within
the set threshold.
the ROD program is activated and
advises the display of tire-acquired parameters.
If you select the icon, the measured tread and
drift values are displayed..
SPIN TYPE
wheel unbalance detection and
radial run-out acquisition of the complete wheel
or wheel rim
wheel unbalance detection and