Gorenje TC100ZW Gebrauchsanweisung Seite 26

HEAT PUMP OPERATION
The heat pump can be operated using an LCD touch screen (Fig. 9). If you press
anywhere on the screen, the screen lights up. When the screen is lit up, the operation
fields are active.
After the heat pump has been connected to the water supply mains, heating network,
power supply network, and a water-filled boiler, it is ready for operation. The heat
pump heats the water in the range 10 °C - 55 °C. From 55 °C - 75 °C the water is
heated by electrical heaters.
Legend:
1 - Signalization of the operation of solar
collectors**
2 - Alternative source of heating turned on
(heaters)
3 - Signalization of the operation of the oil
boiler**
4 - Indication, overview of operation errors,
entrance into the service menu
5 - Display and setup of temperature in °C
6 - Start and setup of the VACATION
programme
7 - Day of the week
(1 .. Monday, ..., 7 .. Sunday)
8 - Reducing the value
9 - Heat pump on/off switch
10 - Increasing the value
Starting/stopping the heat pump

To start the heat pump hold field no. 9.
When starting the unit, system verification is switched on first; it operates for 1
minute (symbol no. 20 is displayed). If the temperature and the flow rate of the inlet
heating water are appropriate, the controller also turns on the compressor and the
heat pump operates in the normal mode (symbols no. 16 and 20 are displayed).
The heat pump is on, the display is not illuminated.
26
Fig. 9: LCD touch screen
11 - TIMER start and setup
12 - Time setup and display
13 - Start-up of quick heating "TURBO"
14 - Indicator of the heating element operation
15 - Start-up of heating to the maximum
temperature level
16 - Signalization of compressor operation
17 - Signalization of anti-legionella programme
operation
18 - Warm water quantity display
19 - Signalization of defrosting **
20 - Signalization of fan operation **
** function is not used in versions TC .. ZW