Dürkopp Adler M-Type 869 Serviceanleitung Seite 60

An bauanleitung pneumatische Füsschenlüftung FLP 14-1
In struc tions for fitting pneumatic sewing foot lift FLP 14-1
2.3 Fit and connect the maintenance unit
8
9
10
Aus ga be/Edi ti on:
10. 2006
Bausatz / Kit 0867 590354
– Screw the hose nozzle 10 in the cubical connection 12 of the
maintenance unit 13.
– Remove the connecting piece 8 with the washers from the
maintenance unit 13 and replace it against the screw
connection Wi-E 9.
– Screw the maintenance unit 13 on the stand in such a way
that the water separator shows vertically downward. If you
have the stand MG 55-3, fit the maintenance unit 13 at the
cross bar on the right below the drive,
– Lead the hose coming out of the sewing machine to the new
bars 3. When cutting off the hose, make sure that it is not
under tension and plug it into the screw connection GD-E 6.
– Connect the screw connection GD-E 5 and the screw
connection Wi-E 9 at the maintenance unit with the remaining
hose.
– Screw the coupling box 11 to your compressed-air supply.
– Put the Ideal clip 15 on the pressure line 16. Then push the
pressure line 16 on the hose nozzle 10 at the maintenance
unit 13. Secure the pressure line on the connection piece 10
11
by the Ideal clip 15.
– Plug the coupling plug 14 of the pressure line 16 in the
coupling box 11 of your compressed-air supply.
14
15
16
ATTENTION!
The operating pressure is 6 bar.
Check at the maintenance unit whether 6 bar is indicated!
If necessary, adjust the pressure at the maintenance unit to 6 bar
before actuating the pneumatic foot lift.
Prin ted in Fe de ral Re pub lic of Germany
5 6 12 13
Blatt: 8
Sheet:
Tei le-Nr./ Part-No.:
0791 867704
9
von 8
from