Before You Start; Assembly; Assembly Of The Handle - Shindaiwa T2510X Bedienungsanleitung

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.

Assembly of the handle

Install the handle so that it does not hide any of the safety decals.
1. Square nut
2. Barrier
3. Handle
1. Lower cap retaining
screw
2. Lower cap
3. Handle positioning la-
bel
WARNING
CAUTION
4. About 250 mm
5. Bolt
4. Band
5. Handlebar
6. Engine

Before you start

Before you start
Loop handle version
1. Put the 4 square nuts into the frame of barrier.
2. Fit the handle and barrier over the outer pipe and tighten the
4 bolts.
3. Position the handle about 250 mm ahead of the throttle
housing end.
4. Secure the handle by alternately tightening the four bolts in
a diagonal or "crisscross" fashion.
U-handle
1. Use the 4 mm L-wrench to remove the lower cap retaining
screws from the handlebar bracket.
2. Position the handle on the outer tube forward of Handle po-
sitioning label as shown in figure. Reassemble the lower cap
to the handlebar bracket in the reverse order of disassembly.
3. Locate the handle in the best position for operator comfort.
4. Firmly tighten both lower cap retaining screws.
5. Secure the cable to the outer pipe with the 2 bands as the
illustration shows. The 2 bands are in the tool bag.
Adjust throttle lever free play
The throttle lever free play should be approximately 4-6 mm.
Make sure that the throttle lever operates smoothly without bind-
ing. If it becomes necessary to adjust the lever free play, follow
the procedures and illustrations that follow.
15