Herunterladen Inhalt Inhalt Diese Seite drucken

Holmatro CT 5111 Betriebsanleitung Seite 40

Vorschau ausblenden Andere Handbücher für CT 5111:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 71
EN
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.
5.7.2
CT 5117
Refer to Fig. 11
Make sure that the blades are slightly open.
Slide the latch (A) towards the end of the pulling tip.
Place the pulling adapter (B) over the spreading tip (C).
Release the latch (A) so that the pulling tip is locked on the spreading tip.
5.7.3
CT 5160
Refer to Fig. 10
Make sure that the blades are slightly open.
Push (A) and pull (B) the pin out untill it locks.
Remove the spreading tips from the blades (C).
Refer to Fig. 4
Place the pulling adapters over the blades.
Push pins in completely untill they lock into the position as shown.
5.8
Folding the carrying handle (Fig. 14)
Move the carrying handle locking bar (11) upwards (2).
Fold the carrying handle close to a preferred position, release the locking bar (11) and rotate the
carrying handle until it locks.
5.9
Rotating the carrying handle (Fig. 14)
Push the carrying handle locking knob (4) inwards.
Rotate the carrying handle close to a preferred position, release the locking knob (4) and rotate the
carrying handle until it locks.
6
Use
6.1
General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
Never try to connect or disconnect hydraulic couplers if the equipment is being used or if the
system is under pressure.
CAUTION
Prevent kinking: Do not use the hose with damaged bend restrictors and do not bend the
hose beyond the minimum bending radius of 75 mm.
Do not pull the hose to move a tool or a pump.
40
916.001.554_002
CT51** (RH)(ST)

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis