Programming Via Manual Scan; Programming Via The Learning Function - Silvercrest SFS 18 A1 Bedienungsanleitung

switched off, press the device button "A" (6)
immediately to stop the automatic search mode. Then
switch the device on again.
5. Now, check whether the buttons of the remote control
work correctly. If this is not the case, start scanning
again to find a suitable code.

Programming via manual scan

1. The device that you want to use must be switched on.
2. Point the remote control at the device. Press and hold
the selected device button, for example, "A" (6), for
approx. 3 seconds. Once the blue LED (4) lights up
continuously, the remote control is in manual search
mode.
3. Press the "VOL+" button (8) approximately every 1.5
seconds. Once the volume of your device changes or
the device is switched off, check whether the other
buttons on the remote control work correctly.
4. If the other buttons do not work, continue the manual
search by pressing the "VOL+" button (8) every 1.5
seconds.
5. If the other buttons work, save the code by pressing the
device button "A" (6).
6. The manual search is cancelled automatically if no entry
is made within 30 seconds.

Programming via the learning function

This function provides the option of transferring the code of
each button individually from your original remote control.
1. Press and hold the selected device button, for example,
"A" (6), until the corresponding LED lights up
continuously. Enter 9999 using the number buttons
(12). The remote control is now in learning mode.
2. Place the original remote control so that its IR LED and
the IR LED (2) of the remote control for seniors are
against each other with only a distance of
approximately 3cm at most between them.
3. First, press the button which you want to set on the
remote control for seniors. The LED then flashes
approximately 3 times per second. On the original
remote control, press the relevant button whose code
you want to copy. The successful transfer of the button
SilverCrest SFS 18 A1
English - 71