Programming By Manual Code Input - Silvercrest SFB 10.1 B2, Betriebsanleitung

number 5 the display skips to the letter "J". The first brand
is "JEC"*. If, for example, you own a "Kenwood"* brand
device, continue leafing with the 4 button t until this
brand name appears. (* All brand names used here are
trademarks of the corresponding manufacturer.)
7. The majority of manufacturers use several different codes
for the remote control. You must now ascertain which of
the available codes is best suited to your device. On the
right underneath the brand name the relevent code will
be shown in the LCD display q.
8. To test the code, point the remote control at the actual
device and press the buttons that correspond to the func-
tions of this device (except 34t, OK l, EXIT y,
the device buttons e or the numeric buttons o).
9. If most of the buttons function press the OK button l to
save the setting. In the LCD display q "OK" appears.
Subsequently the menu will close automatically.
10. If, however, none or only a few of the buttons function
select with the  or  button t the next code and test
again as described in step 8.
11. WiththeEXITbuttonyyoumovebackonelevelinthe
menu.
Repeat these operational steps for all devices that you would
like to control with the remote control.

Programming by manual code input

In this mode the remote control can be programmed by direct
input of a code number. You can obtain the necessary code
number from the enclosed manufacturers directory with device
code list. In the event that the new code is invalid the last valid
programmed code will be restored.
1. Press the device button e for the device that you want to
programme the remote control.
2. HolddowntheSbuttonrforalittlelongerthan3sec-
onds."LANGUAGESETUP"appearsintheLCDdisplay
q.Withtheorbuttontselect"CODESETUP"and
confirmwiththeOKbuttonl.
3. "ENTER CODE" now appears in the LCD display q. To
access this function press the OK button l.
4. In the LCD display q appears the presently used code for
the selected device. Now the first digit of the code blinks
and waits for your code input. Enter the new four digit
code via the number buttons o. After entering the fourth
digit the whole code flashes. You can now test if the URC
can control the device you want with this code. Press
those keys that correspond to the functions of the device,
with a TV set for example, PROG +/–. If the device re-
acts as required, confirm the code input with the OK but-
ton l. If it does not, enter the next possible code from the
list and try again.
5. If the entered CODE is valid the code will be saved. In
the LCD display q "OK" appears briefly. Subsequently
- 12 -