Setting The Time Manually - Auriol HD-1688 Anleitung

The reception of the DCF radio time signal by the wall clock can also
be started manually.
Press and keep pressed the REC button
wall clock attempts to receive the DCF radio time signal. This process
takes a few minutes to complete.
Note: If the wall clock was not able to receive the DCF radio time
signal because of errors, e.g. due your location to being at too great a
distance from the transmitter or for other reasons, you can set the time
manually. The manually set value is overwritten as soon as reception
of the DCF radio time signal is successful.

Setting the time manually

Press and keep pressed the M.SET button
The wall clock switches into manual mode.
Press and keep pressed the M.SET button again until the hands
reach the correct position for you to set the time.
Briefly pressing the M.SET button moves the hands forward in one
minute steps to enable you to set the current time manually.
Note: After 8 seconds without pressing the M.SET button, the
wall clock switches out of manual mode and keeps the time as
normal. The manually set value is overwritten as soon as reception
of the DCF radio time signal is successful.
63991_aur_Wanduhr_Content_LB5.indd 37
Operation
at least 5 seconds. The
3
at least 3 seconds.
1
GB/MT 37
26.07.11 09:05