HomeMatic IP HmIPW-BRC2 Installations- Und Bedienungsanleitung Seite 33

Hazard information
The device is part of the building installation.
Observe the relevant national standards and
directives during planning and set-up. The device
is intended for operation within the Homematic IP
Wired bus only. The Homematic IP Wired bus is a
SELV power circuit. Common cable routing of
power supply and the Homematic IP Wired bus in
installation or junction boxes is not permitted.
The required isolation for power supply of the
building installation to the Homematic IP Wired
bus must be observed at all times. Non-
compliance with the installation instructions can
cause fire or introduce other hazards.
The device may only be used for fixed installations.
The device must be securely attached within a
fixed installation.
Using the device for any purpose other than that
described in this operating manual does not fall
within the scope of intended use and shall
invalidate any warranty or liability.
The device may only be operated within domestic
environment, in business and trade areas as well
as in small enterprises.
33