Herunterladen Inhalt Inhalt Diese Seite drucken

Bosch Thermotechnik TR 200 Handbuch Seite 21

Vorschau ausblenden Andere Handbücher für Thermotechnik TR 200:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

TR 200
The respective yellow control light (i) is on.
The respective red control light (l) is off.
The standard heating mode set at the time
switch is ignored.
The economical operating mode will be active
until
• midnight (0000 hours)
or
• the button
(h) is depressed again;
the regulator is set back to automatic oper-
ating mode
or
• the button
(g) is depressed;
the regulator is set to continuous operating
mode.
In all cases the respective yellow control light
(i) will turn off and the regulator will regulate
the temperature to the set values.
Use this mode if you exceptionally
Tip
leave your house (e.g. for shopping) and the
house should not be heated for this time. As
soon as you are back depress the button
again, the regulator is operating in automatic
mode again and will heat according to the set
temperature.
If you leave the house in the evening or if
you would like to go to bed early depress the
button (h). The regulator terminates the eco-
nomical heating mode at midnight and will
switch back to the usual automatic operating
mode the next morning.
nd
6.2
The "2
operating range"
nd
The "2
operating range" is accessible after
opening the lid.
When the lid is opened the programming
mode is switched on automatically. The dis-
play depends on the setting of the control
knob (n).
15°C
10
20
6.2.1Control knob
25
5
30
temperature" (m)
With this control knob
to which the regulator must regulate in the au-
tomatic operating mode when set to "econom-
ic", as well as in "economical operation
mode" (h).
(h)
"economic
(m) the temperature
6.2.2 General information on the timer
The time switch makes it possible to automat-
ically switch on the heating system up to three
times a day at a pre-determined time and to
automatically switch it off three times a day a
pre-determined time.
Those times can be determined individually
for each day.
6.2.3 Control knob set to
"Setting the clock"
Setting the time
Turn the control knob (n) to
Note:
At initial operation or after a longer
power failure the symbol
is displayed. In this case set the
present day, then depress the button
(q) .
The display (e) shows:
Set clock +/-
12:00
4217-16.1/G
The time is set by depressing the buttons "-"
(o) or "+" (p) .
Briefly depressing the button alters the time by
1 minute, when the button is depressed for a
longer period the time runs faster forward or
backward. The seconds are always set to "0".
As soon as the button is released the clock will
operate normally.
Times before 1200 hrs. (12 noon) can
Tip
be set faster with the "–" button (o).
When no more alterations are necessary
close the lid.
The display (e) shows:
17:53 21.5°C
4217-22.1/G
.
Select day +/-
21

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis