Inhaltsverzeichnis
Werbung
English
Key activation
Drying
Water hardness
Resin liters
Code ...
Programming- Engineer Mode
Option
20,0
Option
3,0
Regeneration
1
Regeneration
1
Key reading
Series ...
Press “+” or “-” to change the key activation time
(from 0.0 to 120.0 in 5 second-steps).
If the key is set at “0.0”, once it has touched the
sensor it will remain activated. Touch the sensor
again to deactivate.
If another value is set, for example “10.0”, the key
will remain activated for 10 seconds after the last
operation.
This is the activation time in seconds of the
drying solenoid valve.
Press “+” or “-” to change the time (in 0.1 second-
steps).
After having performed the water hardness tests
press the “+” or “-” keys to set the value on the
display (from 0 to 50 in steps of 5).
N.B. If a 0 value of water hardness is set, the
message “Regenerate Resin” will be deactivated.
Take the data of the number of resin liters from the
softener and set it using the “+” or “-” keys.
The value set must lie within 1 to 20 in 1-liter steps.
Rest the key on the sensor to read the code
and series of the key to order a spare.
444
Press the key "
". The
following message will be
displayed:
To save the data, set “YES” (using the “+” or “-” keys) and touch the
sensor with the “TECHNICIAN” key. Keep the key in position until the
operation has been completed (“NO” is displayed).
444
Press the key "
". The
following message will be
displayed:
To load the data, set “YES” (using the “+” or “-” keys) and touch the
sensor with the “TECHNICIAN” key. Keep the key in position until the
operation has been completed (“NO” is displayed).
English
Key reading
4
Data OUT
NO
Key reading
4
Data IN
NO
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
