SICE S 560 Betriebsanleitung Seite 52

9) Move the tool carrier arm back from the edge of the rim.
Release the hook and tip the arm to its non-working position.
Move the tool carrier arm to the inside plane of the wheel.
10) Turn the tool head 180°.
Lower the arm to its working position.
11) Turn the spindle and at the same time bring the bead loosener disk up against
the tyre following the contour of the split-ring until the second bead has been broken.
NB: Lubricate during this process.
Continue to move the disk forward until about half the tyre has demounted from
the rim (See Fig. K).
12) Move the tool carrier arm to its non-working position.
13) Lower the spindle until the wheel is resting on the platform.
14) Take the mobile control unit to work position B.
15) Translate the turntable inward until the tyre comes out of the rim completely,
taking care not to damage the valve.
MOUNTING
1) Move the tool carrier arm to its non-working position.
If the rim has been removed from the spindle, put it back on the spindle as described in the section on "CLAMPING THE WHEEL".
NB: If the tyre is tubed, position the rim with the valve slot at the bottom (6 o'clock).
2) Lubricate both beads and the rim with tyre manufacturer recommended lubricant.
3) Take the mobile control unit to work position B.
4) Translate the turntable inward to create the space necessary for lifting the tyre on the platform.
NB: If the tyre is tubed, position the rim with the valve slot at the bottom (6 o'clock).
5) Lower or raise the spindle to centre the rim and the tyre.
6) Translate the turntable outward so the rim can be inserted in the tyre.
CAUTION! If the tyre is tubed push the valve inside so as not to damage it.
Move forward with the platform until rim is completely in the tyre.
7) Bring the tool carrier arm to the outside plane and lower it to its work position
with the disk towards the wheel.
NB: If the tyre is not inserted sufficiently on the rim, move the spindle until the
tyre bead is by the disk. Bring the disk forward (with the spindle turning) until it
is completely inserted.
8) Put the split-ring on the rim and then install the locking ring with the help of
the disk as shown in Fig. Y.
9) Move the tool carrier arm to its non-working position.
10) Lower the turntable until the wheel touches the platform.
11) Close the arms of the spindle completely.
Support the wheel to prevent it falling off.
S 560
52
ENGLISH • Instructions manual
K
Y