How Do I Detect The Set Drive; How Do I Determine The Software And Hardware Version; Maintenance; Cleaning - RK Rose+Krieger RK MultiControl II duo Montageanleitung

6.7.1 How do I detect the set drive?

The controller is set in the factory to a given drive type.
The drive type is stated on the configuration sticker, as can be seen in Figure 21. This
sticker can be found on every control. In our example, the control is configured for the
"Multilift II" drive (Code: 11).
Code:
Version:
Drive:
HW/SW
Order no.:

6.7.2 How do I determine the software and hardware version?

The configuration plate shows the hardware (HW) and software (SW) versions as well
as the drive type.
If you use a hand switch with 6 function keys and a display, you can
also
→ "Control" → "Software and hardware version" menu item.
6.8

Maintenance

Controllers do not require any maintenance.
You may only work on controllers in accordance with these instructions. If there is a fault with
the device, we recommend that you contact our customer service (see chapter 1) or send in
the device for repair.
6.9

Cleaning

If necessary, you can clean the hand switch with a clean, lint-free cloth and a mild soap solution.
MultiControl II duo and MultiControl II quadro assembly instructions
Order number
Configuration (Basic/Premium)
Drive type
Hardware version / software version
Order number
display the software
Figure 21 - Configuration sticker
and hardware version using the "Info"
127