When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb; If Something Does Not Work - Zanussi ZRB 30 JC Gebrauchsanleitung

GB
When the refrigerator
is not in use
In case the appliance will not be used for a long time fol-
low these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb
can be changed. (Type of the bulb: Mignon 322, 230 V,
15 W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence the development of
the adequate temperatures.

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance
goes with certain sounds (compressor- and circu-
lating sound). This is not trouble, this goes together with
the operation of the appliance.
We draw it to your attention again that the appliance oper-
ates discontinuously, so the stopping of compressor
does not mean being no-current. That is why you must
not touch the electrical parts of the appliance before
breaking the circuit.
48