Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - Zanussi ZRA 627CW Gebrauchsanleitung

Regular cleaning

It is recommended to wash the inside of the refrigerator in
3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using
lukewarm water and wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
Dust and dirt collected on the back of the refrigerator,
condenser is recommended to be removed and clean the
evaporative tray on top of the compressor once or twice a
year.

When the refrigerator is not in use

In case the appliance will not be used for a long time follow
these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information is
given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes with
certain sounds (compressor- and circulating sound). This is
not trouble, but means normal operation.
Problem
The appliance does not Thermostatic control is set too low.
cool sufficiently
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The appliance cools too The thermostatic control is set too high.
hard
The appliance does not Plug is not connected to the mains socket
cool at all properly.
There is no voltage in the mains socket.
Thermostatic control is in "0" position.
The appliance is noisy The appliance is not supported properly.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb can
be changed. (Type of the bulb: Mignon 322, 230 V, 15 W,
E 14 thread)
After changing bulb replace the lamp cover, screw the plate
screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.
current. That is why you must not touch the electrical parts
of the appliance before breaking the circuit.
Possible cause
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
Solution
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four
feet should be on the floor).
GB
29