Sartorius LMA316PA Betriebsanleitung Seite 44

WLM6009-a10081
Quick guide to measuring
Start unit
1. Turn on the unit using the On/Off switch at the back.
The software will launch automatically (the screen will turn blank while it is loading). When the
user interface appears on the screen the unit is ready to operate.
2. You may be asked to log on. If so, enter your user name and password and press Apply.
Recommendation: Wait a couple of minutes before you start measuring after turning the unit on.
This will ensure that the operating temperature of the unit is perfect.
Taking measurements
3. Pick Measurement from the menu unless the mode shown above the on-screen table is Measu-
rement already.
4. Check if the line below the Mode box has the correct product. To analyse another product, open
the menu, choose Measurement > Product choice, and select a product.
5. To start measuring, press the Start button.
6. Follow the instructions shown on the status line.
In case the sensor still contains any product, you are prompted to Please empty! the sensor.
Remove the product and put in an empty beaker.
7. Fill the sensor as soon as Please fill! is displayed, and insert the Pt 100 temperature sensor if
necessary. The device performs the measurement and the measured value is displayed.
8. Save the result by pressing the Save control.
9. Depending on the sensor you are using or the system settings you made, you may be asked to
turn the sample or feed the sensor a new sample. Repeat steps 6 to 8.
10. The dialog for entering a remark is shown. Enter the number of the sample, for example, then
press Apply.
Printing measured values
If a printer is connected, you can output the analysis results to it.
1. Open the menu and choose Measurement > Table > Print.
2. Select the parts of the table you wish to print. To print the entire table, press All.
3. Press Print. The normal Print dialog pops up.
4. Change the settings as necessary, then press Print.
Turn off unit
Turn off the unit using the On/Off switch at the back.
You do not need to exit the operating software first.
44
LMA316PA / LMA321PA - Quick guide to measuring
Mode
Selected product