Werbung
5
Technical Information
Pin Functions
Controller Commands Mode
HV Channel On/Off Setting
"A0ns"[Enter] where :
HV Channel Start/Protect Mode Setting
"C0ns"[Enter] where :
Clear Fault (Reset)
"F0n"[Enter] where:
F0 = HV Channel Serial Command for Fault resetClear Fault (Reset)
"F0n"
Max Output Voltage setting
"H0nxxxx"[Enter] where:
86/106
A0 = HV Channel Serial Command for
Status Set
N = HV Channel Number 1 or 2
s
= 0 for OFF, 1 for ON
C0
=
HV Channel Serial Command for
n
=
HV Channel Number 1 or 2
s
=
0 for START mode, 1 for PROTECT mode
n = HV Channel number 1 or 2
H0 = HV Channel Serial Command for Voltage Target
n = HV Channel number 1 or 2 or 3
xxxx = Voltage Target (min 3000 V, max 5000 V in
50 V steps)
Ion Pumps Control Unit (No Battery) User Manual / 87-900-123-01 (B)
Start/Protect Setting
Werbung
Kapitel
