Correct Handling Of The Battery Charger - Parkside PTHSA 20-Li A2 Originalbetriebsanleitung

from paper clips, coins, keys,
nails, screws and other small
metal objects, which could
cause bridging of the contacts.
A short circuit between the bat-
tery contacts may cause burns
or fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event
of accidental contact, rinse off
with water. If the liquid gets into
eyes, seek medical assistance.
Leaking battery fluid may cause
skin irritations or burns.
Special safety directions for
battery-operated tools
a) Ensure that the device is
switched off before inserting
the battery. Inserting a bat-
tery into a power tool that is
switched on may result in ac-
cidents.
b) Recharge the batteries indoors
only because the battery charger
is designed for indoor use only.
c) To reduce the electric shock
hazard, unplug the battery
charger from the mains before
cleaning the charger.
d) Do not subject the battery to
strong sunlight over long pe-
riods and do not leave it on
a heater. Heat damages the
battery and there is a risk of
explosion.
e) Allow a hot battery to cool be-
fore charging.
f) Do not open up the battery and
avoid mechanical damage to
the battery. Risk of short circuit
and fumes may be emitted that
irritate the respiratory tract.
Ensure fresh air and seek medi-
cal assistance in the event of
discomfort.
g) Do not use non-rechargeable
batteries!
h) Do not use any accessories
that are not recommended by
PARKSIDE. This can result in
electric shock or fire.
Correct handling of the
battery charger
• Keep the equipment away from
children and pets. Children
should be supervised in order
to ensure that they do not play
with the equipment.
• To charge the battery, use only
the charger supplied.
Risk of fire and explosion. This
ensures that the safety of the de-
vice is maintained.
• Before each use, check the charg-
er, cable and plug and have them
repaired by qualified profession-
als and only with original parts.
Do not use a defective charger
and do not open it up yourself.
This ensures that the safety of the
device is maintained.
• Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specifications on the charger rat-
ing plate. Risk of electric shock.
• Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
• Keep the charger clean and
away from wet and rain. Do
not use the charger outdoors.
IE NI
7