Futurelight EYE-740 QCL ZOOM Benutzerhandbuch Seite 48

Led moving head wash

Inhaltsverzeichnis

Verfügbare Sprachen

Universe

With this function you can select the universe.

With the function "DMX on cable", you can loop-through the DMX signal via DMX cable.

Reload Default

With this function you can restore the factory settings of the device. The different settings (marked in the

table) will be set back to the default values (shaded).

Program

Play

DMX Receive

With this function, you can set the device to the DMX mode.

Slave Receive

With this function, you can define the device as slave. You can choose one of three different Slave

programs. For further information see „Edit Prog".

Sequence

With this function, you can run the internal program. You can select the desired program under "Select

Chase". You can set the number of steps under "Edit Chase". You can edit the individual scenes under "Edit

Scenes". With this function, you can run the individual scenes either automatically, i.e. with the adjusted

Step-Time. The selection "Alone" means Stand Alone-mode and "Master" that the device is defined as

master.

Music

With this function, you can run the internal program sound-controlled. The selection "Alone" means Stand

Alone-mode and "Master" that the device is defined as master.

Program selection for auto program

With this function, you can select the program for the Program Run.

Edit chase

With this function, you can edit the internal programs.

Edit scenes

With this function, you can edit the scenes of the internal programs.

Rec. Controller

The device features an integrated DMX-recorder by which you can transmit the programmed scenes from

your DMX-controller to the device. Adjust the desired scene numbers by pressing Up or Down (from – to).

When you call up the scenes on your controller, they will automatically be transmitted to the device.

Excursion:

A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different

Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.

The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned

to. If e.g. a Slave unit is set to „Slave 1" in the menu „Set to Slave", the Master unit sends „Auto Program

Part 1" to the Slave unit. If set to „Slave 2", the Slave unit receives „Chase Part 2".

To start a Auto Program please proceed as follows:

1.Slave-Setting• Select "Program" by pressing Up or Down.