INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock
fastener
The device can be fastened via its base to a truss or similar rigging structure in any orientation without
altering its operation characteristics. The device must never be fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware and follow the
instructions mentioned at the bottom of the base. Screw both clamps via a M10 screw and self-locking
nut onto the Omega-holder. Insert the two quick-lock fasteners of the Omega-holders into the respective
holes on the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
4
Secure the device with a safety bond or other
secondary
attachment.
attachment must be sufficiently dimensioned in
accordance
with
regulations and constructed in a way that no part of
the installation can fall down if the main attachment
fails. Install the safety bond by inserting the quick
link in the safety hole on the bottom of the
the safety bond over the trussing system etc. Insert
the end in the quick link and tighten the fixation
screw. Fasten the safety bond in such a way that, in
the event of a fall, the maximum drop distance of the
device will not exceed 20 cm.
5
After installation, the device requires inspections
periodically to prevent the possibility of rot,
deformation and looseness.
2
4
This
secondary
the
latest
industrial
base.
3
1
safety
safety
Pull
33/52
00127396, Version 1.0