ENGLISH
Problem
DRIVE PEDAL
The machine moves even if the drive pedal is
released
CAB HEATING
There is no hot air
CAB CLIMATE CONTROL SYSTEM
There is no fresh air
DIESEL ENGINE
When turning the ignition key, the engine does
not start
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
–
Brooms
–
Engine oil
–
Hydraulic system oil
–
Hydraulic system oil fi lters
–
Plastic components
–
Electrical and electronic components
NOTE
Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
36
USER MANUAL
Possible cause
The drive pedal is misadjusted
The valve or the hot water feed hoses are
broken
There are water leaks from the heater
The switch is deactivated
The fuse is blown
The compressor does not turn because the
drive belt is loosen/broken
There are gas leaks from the system
The expansion valve is faulty
The switch is deactivated
The fuse is blown
There is an open in the gas pressure switch
The relay is burnt
The drive pedal is pressed
33015501(3)2008-02 A
Remedy
Adjust
Replace
Replace
Activate
Replace
Adjust the tension/replace the belt
Repair the leak and integrate the gas
Replace
Activate
Replace
Replace
Replace
Do not press the drive pedal when starting the
engine.
RS 501