Startup; Servicing The Product; Disposing Of The Product - Grundfos Liftaway C Montage- Und Betriebsanleitung

11. Startup

CAUTION
Biological hazard
Minor or moderate personal injury
- The product is only to be use with
rainwater or grey wastewater.
1. Check that all pipes and connections are tight.
2. Fill water from one of the connected units into the
tank, and check that the pump starts.
If the pump starts, the lifting station is ready for
use.
If the pump does not start, check that the lever
arm and the float switch have been fitted
correctly and can move freely.
See section Fault Finding Chart in the installation
and operating instructions for the pump.

12. Servicing the product

If the product is stored for winter, make
sure to empty the tank, or take antifreeze
precautions.
DANGER
Electric shock
Death or serious personal injury
- Switch off the power supply before you
start any work on the product.
- Make sure that the power cannot be
switched on accidentally.
CAUTION
Biological hazard
Minor or moderate personal injury
- The product will be classified as
contaminated if it has been used for a
liquid which is injurious to health or
toxic.
- Wear personal protective equipment.
Liftaway C 40-1 with a Unilift KP pump is practically
maintenance-free. However, regular checks and
cleaning will ensure faultless operation and a long
operating life.
To prevent unnecessary pumping, it should be
checked that the connected units are tight.
For pump maintenance, see the installation and
operating instructions of the pump.
Cleaning the tank
For systems which are used very rarely, we
recommend occasional, internal cleaning.
When the tank has been emptied, the pump must be
vented. See step 8 in section
venting of pump.
Cleaning the units connected
After cleaning the units connected, flush the lifting
station once more with clean water.
12
10. Mounting and

13. Disposing of the product

This product or parts of it must be disposed of in an
environmentally sound way:
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The crossed-out wheelie bin symbol on
a product means that it must be
disposed of separately from household
waste. When a product marked with this
symbol reaches its end of life, take it to a
collection point designated by the local
waste disposal authorities. The separate collection
and recycling of such products will help protect the
environment and human health.
See also end-of-life information at
www.grundfos.com/product-recycling.