Ryobi RCS-3535C2 Bedienungsanleitung Seite 38

GB
F D E I
MAINTENANCE
Drain all bar and chain oil from tank into a container
approved for oil.
Clean all foreign material from the saw.
Store it in a well-ventilated place that is inaccessible to
children.
Problem
Engine will not start. [Make
sure ignition switch is in the
RUN ( l ) position.]
Engine starts but will not
accelerate properly.
Engine starts, then dies.
Engine starts but will not run
properly at high speed.
Engine does not reach full
speed and/or emits excessive
smoke.
P NL S DK N FIN GR HU
TROUBLESHOOTING
Possible Cause
No spark.
Engine is fl ooded.
Carburetor requires "L"
(Low Jet) adjustment.
Carburetor requires "L"
(Low Jet) adjustment.
Carburetor requires "H"
(High Jet) adjustment.
Oil/fuel mixture incorrect.
Air fi lter is dirty.
Spark arrestor screen is
dirty.
Carburetor requires "H"
(High Jet) adjustment.
CZ RU RO PL SLO HR TR EST LT
English
NOTE: Keep away from corrosive agents such as
garden chemicals and de-icing salts.
Abide by local regulations for the safe storage and handling
of gasoline. Excess fuel should be used in other 2-cycle
engine powered equipment.
Check spark. Remove air fi lter cover. Remove spark
plug from cylinder. Reattach the spark plug wire and lay
spark plug on top of cylinder with the metal part of plug
touching the cylinder. Pull the starter grip and watch for
spark at spark plug tip. If there is no spark, repeat test
with a new spark plug.
With the ignition switch OFF, remove spark plug. Move
choke knob to RUN position (pushed in completely) and
pull starter grip 15 to 20 times. This will clear excess fuel
from engine. Clean and reinstall spark plug. Set ignition
switch to RUN ( l ) position. Push and fully release primer
bulb 4 times. Pull starter three times with choke knob
at RUN. If engine does not start, move choke knob to
HALF CHOKE and repeat normal starting procedure.
If engine still fails to start, repeat procedure with a new
spark plug.
Contact an authorized service center for carburetor
adjustment.
Contact an authorized service center for carburetor
adjustment.
Contact an authorized service center for carburetor
adjustment.
Use fresh fuel and the correct 2-stroke oil mix ratio.
Clean air fi lter. Refer to Cleaning the Air Cleaner in the
Maintenance section of this manual.
Clean spark arrestor screen. Refer to Cleaning the
Spark Arresting Screen in the Maintenance section
of this manual.
Contact an authorized service center for carburetor
adjustment.
35
LV
Solution
SK BG